Central Connecticut Woodturners

  • Increase font size
  • Default font size
  • Decrease font size

Accurate Reversal

It can be challenging to align your work accurately when reverse mounting a bowl to turn the foot.  Mark the exact center of the bowl before removing the faceplate or chuck.  Remove the faceplate (and bowl) from the lathe, put a dead center in the headstock morse taper, then screw the faceplate back on.  The point on the dead center will leave a clean mark right in the center of the base of the bowl.  You can use that mark to align with a tailstock center.

  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow

facebook


Events

CCW Annual Picnic - Sat August 12th 11am-4pm at Alicia & Butch's house 36 Randall Rd., Lebanon, CT.  Pot Luck.  RSVP - please call Lynda (review club memeber listing ph#)
 
Open Shop Events:
NO OPEN SHOP at Jim Kephart's in August
 
The September meeting will be on Tuesday September 26th at 6:30PM at the Connecticut Valley School of Woodworking at the Manchester Woodcraft.  Eric Holmquist will be demonstrating.  PIZZA PARTY at 6PM too!  Spouse Show & Tell!!