Central Connecticut Woodturners

  • Increase font size
  • Default font size
  • Decrease font size

Wrench As A Go-Gauge

Turners are sometimes advised to use an open end wrench as a gauge for sizing tennons on spindle turnings.  Wrenches are produced oversized so they will slide on to the appropriate nut or cap hex.  If you use a wrench as a size gauge plan on trimming the tennon afterward or purchase an oversized drill bit to match the wrench.
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow
  • An Image Slideshow

facebook


Events

CCW Annual Picnic - Sat August 12th 11am-4pm at Alicia & Butch's house 36 Randall Rd., Lebanon, CT.  Pot Luck.  RSVP - please call Lynda (review club memeber listing ph#)
 
Open Shop Events:
NO OPEN SHOP at Jim Kephart's in August
 
The September meeting will be on Tuesday September 26th at 6:30PM at the Connecticut Valley School of Woodworking at the Manchester Woodcraft.  Eric Holmquist will be demonstrating.  PIZZA PARTY at 6PM too!  Spouse Show & Tell!!